You get a tap and cut threads into the bushing, then you screw a bolt in and
keep turning it. When the bolt bottoms out, keep turning and it will bring
in bushing out of the hole. The bushing threads up the bolt.


"Mel P." wrote in message
news: This e-mail address is being protected from spam bots, you need JavaScript enabled to view it
> SO you're telling me to tap it and then just pull it out with a pliers or
> something or do I need to pull it out with something similar to a pump
> puller set up?
>
>
> Mel
>
> "Speedy Jim" wrote in message
> news:jM0Xi.16$ This e-mail address is being protected from spam bots, you need JavaScript enabled to view it
> > Mel P. wrote:
> >> TO all and Speedy Jim,
> >>
> >> I believe Jim answered the following before for me:
> >>
> >> Is there an easy way to replace the bushing (engine in car)?
> >>
> >> thanx,
> >>
> >> Mel P.
> >
> > There is a special tool for it (of course!),
> > but you can thread a machine tap into the bushing
> > and then screw a bolt in to pull it out with.
> >
> > Jim
>
>